Elements and Controls of the Graphical User Interface
R&S
®
SMW200A
1226User Manual 1175.6632.02 ─ 16
Graphics indicator
Indicates that the corresponding signal is graphically shown.
The symbol covers the identifier of the signal source and is assigned to the corre-
sponding signal line. Digital signals are highlighted green, and the analog signals are
blue.
Connectors
Connector icons represent the interfaces for signal input and output. The symbols cor-
respond to the hardware connectors on the instrument.
The connectors are always bound by a function block and labeled with the
respective signal name. When you select a connector icon, you can fold the block and
the icon, or unfold (toggle mode). In the unfolded state, small LEDs show you whether
the signal is active or not.
Table D-1: Indication of connectors
Connector Icon Denotes Folded view
Digital I/Q signal input (CODER
board)
Digital I/Q output (DAC board)
Analog I/Q input -
Analog I/Q output
RF output -
The LEDs indicate:
●
that a signal is active at the corresponding connector.
●
that a signal source is not active.
Trigger State
Indicates the state of the trigger signal in the baseband domain.
The trigger can be in the following states:
Elements in the Block Diagram
To Next Page
Loading...
