Rohde & Schwarz SMW200A - Page 21

Contents
R&S
®
SMW200A
6User Manual 1175.6632.02 ─ 16
2.5.7 Remote Control........................................................................................................... 121
2.5.8 Remote Operation over VNC...................................................................................... 121
3 Signal Routing and System Configuration...................................... 122
3.1 How the System Configuration Function Supports You in Your Task.................122
3.1.1 Finding Out the System Configuration for a Current Test Case..................................122
3.1.2 From a Test Scenario to the Required System Configuration.....................................124
3.2 Possible Ways to Configure the Signal Flow......................................................... 126
3.2.1 Using the Signal Routing Settings and the Block Diagram......................................... 126
3.2.2 Using the System Configuration Capabilities.............................................................. 127
3.3 Overview of the Input and Output Signals and Interfaces.................................... 129
3.3.1 Physical Location of the Input and Output Interfaces..................................................130
3.3.2 Overview of the Baseband Signal Sources.................................................................132
3.3.3 Overview of the Baseband and RF Output Signals.....................................................133
3.3.4 Important Signal Parameters and Interface's Characteristics..................................... 133
3.3.4.1 Specific Characteristics of the Digital I/Q Interface..................................................... 135
3.3.4.2 Specifics of the Analog I/Q Interfaces......................................................................... 137
3.4 System Configuration Settings................................................................................137
3.4.1 Fading and Baseband Configuration Settings.............................................................138
3.4.2 I/Q Stream Mapper Settings........................................................................................144
3.4.3 External RF and I/Q Settings...................................................................................... 147
3.4.3.1 Connections Configuration and Connection Status Overview Settings...................... 148
3.4.3.2 External Instrument Configuration Settings.................................................................154
Remote Config Settings.............................................................................................. 155
Initialization Sequence Settings.................................................................................. 159
Remote Control Settings............................................................................................. 161
Show Connector..........................................................................................................162
Check Connections Settings....................................................................................... 163
3.4.4 Overview..................................................................................................................... 164
3.5 Signal Routing Settings............................................................................................166
3.6 Digital Baseband Input Settings.............................................................................. 170
3.6.1 General Settings......................................................................................................... 172
3.6.2 Sample Rate Settings................................................................................................. 173
3.6.3 Input Level Settings.....................................................................................................175