Simulating Fading, Adding Noise and Predistortions, and Impairing the Signal
R&S
®
SMW200A
395User Manual 1175.6632.02 ─ 16
The dialog contains the settings for noise level configuration and CW interfering
parameters.
If the instrument is configured to work in Advanced mode ("System Configuration >
Fading/Baseband Configuration > Mode > Advanced") and Coupled Mode is dis-
abled, the dialog consists of more than one side tabs, whereas the number of tabs
corresponds to the number of selected BB Signals (Tx Antennas). The tab name
displays the baseband the settings are related to and the mode the noise is gener-
ated at.
2. To activate the AWGN generator, select "Block Diagram > AWGN > On".
In Advanced mode, a dedicated LED indicates the state of each stream.
Figure 5-4: Representation of the AWGN blocks in "System Configuration > Advanced Mode"
Adding Noise to the Signal
To Next Page
Loading...
