Preface
R&S
®
SMW200A
29User Manual 1175.6632.02 ─ 16
●
File and Data Management
Description of general functions to handle data files and work with the file system
of the instrument
●
General Instrument Functions
Description of the general instrument settings and functions
●
Network Operation and Remote Control
Information on setting up the instrument in a network and controlling it remotely.
●
Remote Control Commands
Remote commands required to configure and perform measurements in a remote
environment, sorted by tasks
Remote commands required to set up the environment and to perform common
tasks on the instrument, sorted by tasks
Programming examples demonstrate the use of many commands and can usually
be executed directly for test purposes
●
Maintenance
Information on tasks required to maintain the operability of the instrument
●
Troubleshooting and Error Messages
Hints and tips on how to handle errors
●
Appendix
Extensive reference information on remote control, hardware interfaces, etc.
●
Glossary
List of often used terms and abbreviations
●
List of Commands and Waveform Tags
Alphabetical list of all remote commands and waveorm tags described in the man-
ual
●
Index
Contents and scope
This description assumes R&S SMW equipped with all availabe options. Depending on
your model and the installed options, some of the functions may not be available on
your instrument.
Notes on screenshots
When describing the functions of the product, we use sample screenshots. These
screenshots are meant to illustrate as much as possible of the provided functions and
possible interdependencies between parameters. The shown values may not represent
realistic usage scenarios.
The screenshots usually show a fully equipped product, that is: with all options instal-
led. Thus, some functions shown in the screenshots may not be available in your par-
ticular product configuration.
About This Manual
To Next Page
Loading...
