Configuring the Signal in the RF Domain
R&S
®
SMW200A
428User Manual 1175.6632.02 ─ 16
Menu item Content Described in ...
Ext. Ref. / LO Coupling
●
Internal reference frequency
●
Local oscillator (LO)
●
LO coupling
Chapter 7.4, "Reference Oscilla-
tor", on page 441 and Chap-
ter 7.5, "Local Oscillator Cou-
pling", on page 448
RF Level
Level
●
RF signal level settings
●
The various possibilities for
setting the level
●
Impact of a downstream
instrument to the level dis-
play
Chapter 7.3, "Configuring RF Fre-
quency and Level", on page 430
Attenuator The electronic step attenuator
settings.
Chapter 7.8.1, "Attenuator",
on page 521
Power on / EMF
●
Determine the state of the
RF signal output at power-on
●
Voltage level display in the
status bar (no-load voltage)
Chapter 11.1.4, "Defining the RF
Signal State On Power On ",
on page 660
Automatic Level Control The automatic adaptive control
system to stabilize the RF output
level.
Chapter 7.8.2, "ALC - Automatic
Level Control", on page 524
User Correction The level correction function for
compensating external losses.
Chapter 7.8.3, "User Correction",
on page 529
RF Measurement
Chapter 7.8.4, "Using Power Sen-
sors", on page 540
NRP Power Viewer Function for monitoring and mea-
suring the RF output power.
Chapter 7.8.4.3, "NRP Power
Viewer", on page 543
NRP Sensor Mapping Function for assigning R&S NRP
power sensors to the four sensor
channels.
Chapter 7.8.4.2, "NRP Sensor
Mapping", on page 541
Analog Modulation All settings for analog modula-
tions, including the LF signal and
some typical examples.
Chapter 7.7, "Analog Modula-
tions", on page 493
Modulation Source
Signal sources for the LF signal:
●
Internal signal generators
●
Externally applied LF signal
●
LF signal shapes
Chapter 7.7.2, "Modulation Sig-
nals", on page 495 and Chap-
ter 7.7.2.4, "Modulation Signal
Waveforms", on page 500
Amplitude / Frequency / Phase
Modulation
AM, FM and PhiM settings. Chapter 7.7.3, "Modulation Set-
tings", on page 502
LF Output Configures the LF signal for out-
put.
Chapter 7.7.3.3, "LF Signal Out-
put Settings", on page 510
Pulse Modulation
Pulse modulation settings:
●
General settings
●
Pulse generator settings
●
Graphical display of the
pulse signal
Chapter 7.7.3.5, "Pulse Modula-
tion", on page 512
Sweep / List Information on configuring an RF
signal with varying frequencies or
amplitudes, either in Sweep or
List Mode.
Chapter 7.6, "Varying the RF Sig-
nal in List or Sweep Mode",
on page 457
How to Access the Functions in the RF Domain?
To Next Page
Loading...
