Configuring the Signal in the RF Domain
R&S
®
SMW200A
497User Manual 1175.6632.02 ─ 16
You can freely assign the LF signals from both paths (A or B) to the outputs. To per-
form the assignment, use the "LF Output" tab. It is available both in the "Modulation"
dialog of path A and path B, but the functionality applies to both paths the same way.
Therefore, the instrument adjusts your settings always in parallel. The "Overview" tab
shows the current configuration graphically, and allows you to modify the assignments
there directly. The assignment of the shown LF output is of course in both paths the
same.
Since there are two LF output connectors, but the R&S SMW can process multiple LF
signals simultaneously, there are some configurations that exclude each other.
See the following examples to the overview tab, the versatile options for configuring
the modulation signals and the graphical representation of the signal flow.
Analog Modulations
To Next Page
Loading...
