Monitoring Signal Characteristics
R&S
®
SMW200A
603User Manual 1175.6632.02 ─ 16
c) Select "IEEE 802.11 WLAN > Marker" and enable two marker signals, each
one indicating of the PPDU part of the frame block:
● "Marker Mode > Marker 1 > Frame Active Part", "Frame Block Index = 1",
"Frame Index = 1"
● "Marker Mode > Marker 2 > Frame Active Part", "Frame Block Index = 2",
"Frame Index = 1"
3. In the task bar, select "System Config > Setup > Baseband Powers" and perform
the following:
a) "Source > Baseband A" and "Output > RF A"
b) "Acquisition > Gated" and "Gate Source > Marker 1"
c) "Duration = 1 s" and "Run Mode > Single"
d) Select "Add" and "Start" to trigger the measurement.
Querying Information on the Baseband Power Levels
To Next Page
Loading...
