ssh2
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1037
ssh2
ssh2 {cipher [3des | blowfish]} {port <portnum>} {compression [on | off]}
{user <username>} {debug <debug_level>} {<username>@} [<host> |
<ipaddress>] {<remote command>} {vr <vr_name>}
Description
Initiates an SSH2 client session to a remote SSH2 server.
Syntax Description
Default
The default settings for SSH2 parameters are as follows:
● cipher—3des encryption
● port—22
● compression—off
● debug_level—0 (zero)
● vr_name—VR-Mgmt
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
3des Specifies that the 3des cipher should be used for encryption. This is the default.
blowfish Specifies that the blowfish cipher should be used for encryption.
portnum Specifies the TCP port number to be used for communicating with the SSH2 client. The
default is port 22.
on Specifies that the data is to be compressed.
off Specifies that compression is not to be used. This is the default.
username Specifies a login name for the remote host, as an alternate to the username@host
parameter. Can be omitted if it is the same as the username on the switch.
debug_level Specifies a debug level. The default is 0. With a default of 0, the range is 1 through 3.
host Specifies the name of the remote host.
ipaddress Specifies the IP address of the remote host.
remote command Specifies a command to be passed to the remote system for execution. The switch does
not support remote commands. The option is only valid if the remote system is a system,
such as a UNIX workstation, that accepts remote commands.
vr_name Specifies the virtual router. The default virtual router is VR-Mgmt.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of switches
do not support user-created VRs.
To Next Page
Loading...