show inline-power slot
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
543
show inline-power slot
show inline-power slot <slot>
Description
Displays inline power information for the specified slot on modular switches.
Syntax Description
Default
N/A.
Usage Guidelines
On modular switches, the output indicates the following inline power status information for each slot:
● Inline power status—The status of inline power. The status conditions are:
■ Enabled
■ Disabled
● Firmware status—The operational status of the slot. The status conditions are:
■ Operational
■ Not operational
■ Disabled
■ Subsystem failure
■ Card not present
■ Slot disabled
● Budgeted power—The amount of power, in watts, that is available to the slot.
● Measured power—The amount of power, in watts, that currently being used by the slot.
● Legacy—The status of the legacy mode, which allows detection of many non-standard PDs.
Example
The following command displays inline power information for slot 3:
show inline-power slot 3
Following is sample output from this command:
Budgeted Measured
Slot Inline-Power Firmware Status Power (Watts) Power (Watts) Legacy
3 Enabled Operational 500 W 441 W Disabled
slot Specifies the slot.
To Next Page
Loading...