Extreme Networks ExtremeWare XOS - Show Eaps

EAPS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1148
show eaps
show eaps {<eapsDomain>} {detail}
Description
Displays EAPS status information.
Syntax Description
Default
N/A.
Usage Guidelines
If you enter the show eaps command without a keyword, the command displays less than with the
detail keyword.
Use the optional domain
eapsDomain parameter to display status information for a specific EAPS
domain.
Some state values are different on a transit node than on a master node.
The fields displayed are as follows:
eapsDomain Specifies the name of an EAPS domain.
detail Specifies all available detail for each domain.
EAPS Enabled: Current state of EAPS on this switch:
• Yes—EAPS is enabled on the switch.
• No—EAPS is not enabled.
EAPS Fast Convergence: Displays only when Fast Convergence is on.
EAPS Display Config Warnings Displays the setting for loop protection messages:
• On—Loop protection messages are displayed (this is the default behavior).
• Off—Loop protection messages are not displayed.
Number of EAPS instances: Number of EAPS domains created. The maximum number of EAPS domains
per switch is 128.
Name: The configured name for this EAPS domain.