Extreme Networks ExtremeWare XOS - Show Svlan

show svlan
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
779
show svlan
show svlan {<svlan_name> {ipv4 | ipv6}} {detail}
Description
Displays SVLAN configuration. SVLANs are used in MAC-in-MAC tunneling (IEEE 802.1ah)
configurations.
Syntax Description
Default
Summary information for all SVLANs on the device.
Usage Guidelines
None.
NOTE
To display the EtherType for IEEE 802.1ah MAC-in-MAC tunneling, use the command show vman ethertype.
Example
The following is an example of the display from the show svlan command:
* BD-10808.8 # show svlan
--------------------------------------------------------------------------------------
Name VID Protocol Addr Flags Proto Ports Virtual
Active router
/Total
--------------------------------------------------------------------------------------
servtest 4090 -------------------- ----------------S ANY 0 /0 VR-Default
--------------------------------------------------------------------------------------
Flags : (C) EAPS Control vlan, (E) ESRP Enabled, (f) IP Forwarding Enabled,
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback
Enabled, (m) IPmc Forwarding Enabled,
(n) IP Multinetting Enabled, (N) Network LogIn vlan,
(o) OSPF Enabled, (p) PIM Enabled,
svlan_name Specifies information is displayed for particular SVLAN.
ipv4 Not supported in ExtremeWare XOS version 11.4.
ipv6 Not supported in ExtremeWare XOS version 11.4.
detail Specifies all information is displayed for each SVLAN.