Extreme Networks ExtremeWare XOS - Show Management

show management
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
193
show management
show management
Description
Displays the SNMP settings configured on the switch.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines:
The following management output is displayed:
● Enable/disable state for Telnet, and SNMP access
● Login statistics
■ Enable/disable state for idle timeouts
■ Maximum number of CLI sessions
● SNMP community strings
● SNMP trap receiver list
For ExtremeWare XOS 11.0 and later, the following management output is also displayed:
● SNMP trap receiver source IP address
● SNMP statistics counter
● SSH access states of enabled, disabled, and module not loaded
● CLI configuration logging
● SNMP access states of v1, v2c disabled and v3 enabled
If all three types of SNMP access are enabled or disabled, SNMP access is displayed as either
Enabled or Disabled.
For ExtremeWare XOS 11.1 and later, the following management output is also displayed:
● Enable/disable state for RMON
For ExtremeWare XOS 11.2 and later, the following management output is also displayed:
● Access-profile usage configured via Access Control Lists (ACLs) for additional Telnet and SSH2
security