Extreme Networks ExtremeWare XOS - Configure Lldp Ports Vendor-Specific Dot3 Max-Frame-Size

configure lldp ports vendor-specific dot3 max-frame-size
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
475
configure lldp ports vendor-specific dot3 max-frame-
size
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-
specific dot3 max-frame-size
Description
Configures the LLDP port to advertise or not advertise its maximum frame size to its neighbors.
Syntax Description
Default
No advertise.
Usage Guidelines
When jumbo frames are not enabled on the specified port, the TLV reports a value of 1518 once you
configure it to advertise. If jumbo frames are enabled, the TLV inserts the configured value for the
jumbo frames.
Example
The following command configures ports 1:12 and 1:13 to advertise the maximum frame size to
neighbors:
configure lldp ports 1:12 - 1:13 advertise vendor-specific dot3 max-frame-size
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
all Specifies all ports on the switch.
port_list Specifies one or more ports or slots and ports.
advertise Specifies to send the information to neighbors.
no-advertise Specifies not to send the information to neighbors.