traceroute
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
109
traceroute
traceroute {vr <vrid>} {ipv4 <host>} {ipv6 <host>} {ttl <number>} {from
<from>} {[port <port>] | icmp}
Description
Enables you to trace the routed path between the switch and a destination endstation.
Syntax Description
Default
N/A.
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created virtual
routers.
Each router along the path is displayed.
Beginning with ExtremeWare XOS 11.2, you can trace the routed path between the switch and the given
IPv6 address.
vr Specifies a virtual router.
NOTE: User-created VRs are not available on the BlackDiamond 8800 series
switch or the Summit X450 family of switches.
vrid Specifies which virtual router.
NOTE: User-created VRs are not available on the BlackDiamond 8800 series
switch or the Summit X450 family of switches.
ipv4 Specifies IPv4 transport.
ipv6 Specifies IPv6 transport.
host Specifies the host of the destination endstation.
ttl <number> Configures the switch to trace up to the time-to-live number of the switch.
from <from> Uses the specified source address in the ICMP packet. If not specified, the
address of the transmitting interface is used.
port <port> Specifies the UDP port number.
icmp Configures the switch to send ICMP echo messages to trace the routed path
between the switch and a destination endstation.
To Next Page
Loading...