Extreme Networks ExtremeWare XOS - Download Image

Configuration and Image Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1900
download image
download image [[<hostname> | <ipaddress>] <filename> {{vr} <vrname>}
| memorycard <filename>] {<partition>} {msm <slotid>}
Description
Downloads a new version of the ExtremeWare XOS software image.
Syntax Description
Default
Stores the downloaded image in the partition selected by the use image command.
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
Prior to downloading an image on the switch, you must download the image you received from
Extreme Networks to a TFTP server on your network. On a modular switch, you can also download the
image to the external compact flash memory card.
hostname Specifies the hostname of the TFTP server from which the image should be
obtained.
ipaddress Specifies the IP address of TFTP server from which the image should be
obtained.
memorycard Specifies that the image should be obtained from the external compact flash
memory card.
NOTE: This parameter is available only on modular switches.
filename Specifies the filename of the new image.
vrname Specifies the name of the virtual router.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
partition Specifies which partition the image should be saved to: primary or secondary.
Select primary to save the image to the primary partition and secondary to save
the image to the secondary partition.
slotid Specifies the MSM where the software image should be downloaded.
• A specifies the MSM installed in slot A.
• B specifies the MSM installed in slot B.
NOTE: This parameter is available only on modular switches.