show lacp lag
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
377
show lacp lag
show lacp lag <group-id> {detail}
Description
Displays LACP, or dynamic link aggregation, settings for the specified LAG.
Syntax Description
Default
N/A.
Usage Guidelines
This command displays the following information about the specified LACP LAG:
● LAG
■ Identifies the particular LAG. This number comes from logical port assigned to the LAG and is
the LAG group ID.
● Actor Sys-Pri
■ Shows the system priority for that LAG.
■ If this number is lower than the number displayed for the Partner Sys-Pri, the system you are
working on is the controlling partner in the LAG.
● Actor Key
■ Automatically generated LACP key.
● Partner MAC
■ Identifies the MAC address for the system connecting to the LAG on the remote end.
● Partner Sys-Pri
■ Shows the system priority for that LAG on the remote end.
■ If this number is lower than the number displayed for the Actor Sys-Pri, the system at the remote
end is the controlling partner in the LAG.
● Partner Key
■ LACP key automatically generated by the system to which this aggregator is connected.
■ If this number is lower than the number displayed for the Actor Key, the partner system is the
controlling partner in the LAG.
● Agg Count
■ Identifies the number of ports added to the aggregator for that LAG.
● Member port
group-id Specifies the LAG group ID you want to display. This is the number of the port
you configured as the logical port of the LAG.
detail Show detailed information.
To Next Page
Loading...