Extreme Networks ExtremeWare XOS - Show Bvlan

VLAN Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
774
show bvlan
show bvlan {<bvlan_name> {ipv4 | ipv6}} {detail}
Description
Displays BVLAN configuration. BVLANs are used in MAC-in-MAC tunneling (IEEE 802.1ah)
configurations.
Syntax Description
Default
Summary information for all BVLANs on the device.
Usage Guidelines
None.
NOTE
To display the EtherType for IEEE 802.1ah MAC-in-MAC tunneling (BVLAN), use the command show vman
ethertype.
Example
The following is an example of the display from the show bvlan command:
* BD-10808.6 # show bvlan
--------------------------------------------------------------------------------------
Name VID Protocol Addr Flags Proto Ports Virtual
Active router
/Total
--------------------------------------------------------------------------------------
test 4091 -------------------- ----------------B ANY 0 /0 VR-Default
--------------------------------------------------------------------------------------
Flags : (C) EAPS Control vlan, (E) ESRP Enabled, (f) IP Forwarding Enabled,
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback
Enabled, (m) IPmc Forwarding Enabled,
(n) IP Multinetting Enabled, (N) Network LogIn vlan,
(o) OSPF Enabled, (p) PIM Enabled,
bvlan_name Specifies information is displayed for particular BVLAN.
ipv4 Not supported in ExtremeWare XOS version 11.4.
ipv6 Not supported in ExtremeWare XOS version 11.4.
detail Specifies all information is displayed for each BVLAN.