uninstall image
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1935
uninstall image
uninstall image <fname> <partition> {msm <slotid>} {reboot}
Description
Uninstalls an ExtremeWare XOS software package.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to uninstall a software package previously installed on the switch.
When you uninstall a software package, the switch prompts you to save your changes to your currently
active configuration file:
Uninstallation of the EXOS module
Do you want to save configuration changes to primary.cfg? (y or n)
Enter y to save the changes to your configuration file. Enter n to not save the changes to your
configuration file.
Local Filename Character Restrictions. This section provides information about the characters supported
by the switch for local and remote filenames.
When specifying a local filename, the switch permits only the following characters:
● Alphabetical letters, upper case and lower case (A-Z, a-z)
● Numerals (0-9)
● Period ( . )
● Dash ( - )
● Underscore ( _ )
fname Specifies the software package to uninstall.
partition Specifies which partition the package was installed to: primary or secondary.
Select primary to remove it from the primary partition and secondary to remove
it from the secondary partition.
slotid Specifies the MSM where the package should be uninstalled.
• A specifies the MSM installed in slot A.
• B specifies the MSM installed in slot B.
NOTE: This parameter is available only on modular switches.
reboot Reboots the switch after the package is uninstalled.
To Next Page
Loading...