Extreme Networks ExtremeWare XOS - Show Ospfv3 Virtual-Link

show ospfv3 virtual-link
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1659
show ospfv3 virtual-link
show ospfv3 {domain <domainName>} virtual-link {{routerid} <router-
identifier> {area} <area-identifier>}
Description
Displays virtual link(s) information.
Syntax Description
Default
N/A.
Usage Guidelines
router-identifier—Router ID for the other end of the link.
area-identifier—Transit area used for connecting the two end-points. The transit area cannot have an
area identifier of 0.0.0.0 and cannot be a stub or NSSA area.
Example
The following command displays information about the virtual link to a particular router:
show ospfv3 virtual-link 1.2.3.4 10.1.6.1
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
domainName Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
router-identifier Specifies a router identifier, a four-byte, dotted decimal number.
area-identifier Specifies an OSPFv3 area, a four-byte, dotted decimal number.