Extreme Networks ExtremeWare XOS - Configure Lldp Ports Vendor-Specific Avaya-Extreme Dot1 Q-Framing

configure lldp ports vendor-specific avaya-extreme dot1q-framing
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
463
configure lldp ports vendor-specific avaya-extreme
dot1q-framing
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-
specific avaya-extreme dot1q-framing [tagged | untagged | auto]
Description
Configures the LLDP port to advertise or not advertise the 802.1q framing configuration to its
neighbors. The Avaya phone uses this proprietary LLDP TLV information. In addition to this LLDP TLV,
you must enable LLLDP as well as configure both the LLDP MED capabilities TLV and the LLDP
network policy TLV.
Syntax Description
Default
No advertise.
Usage Guidelines
Before configuring this LLDP TLV, you must take the following steps:
● Enable LLDP using the enable lldp ports command.
● Enable the LLDP MED capabilities TLV using the configure lldp ports vendor-specific med
capabilities
command.
● Enable the LLDP MED network policy TLV using the configure lldp ports vendor-specific
med policy application
command.
This TLV is used to exchange information about Layer 2 priority tagging between the network
connectivity device (switch) and the Avaya phone.
If you configure the TLV to advertise tagging, the phone uses tagging information, which it retrieves
from the
configure lldp ports vendor-specific med policy application command. If you
configure the TLV to advertise untagged, the phone will not use any tagging, including 802.1q priority
tagging.
all Specifies all ports on the switch.
port_list Specifies one or more ports or slots and ports.
advertise Specifies to send the information to neighbors.
no-advertise Specifies not to send the information to neighbors.
tagged Specifies to use tagging.
NOTE: This parameter applies only when you use the advertise parameter.
untagged Specifies not to use tagging.
NOTE: This parameter applies only when you use the advertise parameter.
auto Specifies following a predetermined sequence (see “Usage Guidelines” below).
NOTE: This parameter applies only when you use the advertise parameter.