configure eaps failtime
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1123
configure eaps failtime
configure eaps <name> failtime <seconds>
Description
Configures the value of the failtimer the master node uses for EAPS health-check packets.
Syntax Description
Default
The default is 3 seconds.
Usage Guidelines
Use the failtime keyword and its associated seconds parameter to specify the amount of time the
master node waits before the failtimer expires. The
seconds parameter must be set greater than the
configured value for
hellotime. The default value is three seconds.
Increasing the
failtime value provides more protection by waiting longer to receive a health-check
packet when the network is congested.
NOTE
You configure the action taken when the failtimer expires by using the configure eaps failtime expiry-
action command.
In ExtremeWare XOS 11.0, the failtimer range was 2 to 60 seconds.
Example
The following command configures the failtimer value for the EAPS domain “eaps_1” to 15 seconds:
configure eaps eaps_1 failtime 15
History
This command was first available in ExtremeWare XOS 11.0.
The range for the failtimer was changed to 2 to 300 seconds in ExtremeWare XOS 11.1. The default value
for the failtimer remains unchanged.
name Specifies the name of an EAPS domain.
seconds Specifies the number of seconds the master node waits to receive a health-
check packet before the failtimer expires. Default is 3 seconds, and the range
is 2 to 300 seconds.
To Next Page
Loading...