Extreme Networks ExtremeWare XOS - Enable Bgp Peer-Group Capability

enable bgp peer-group capability
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1769
enable bgp peer-group capability
enable bgp peer-group <peer-group-name> capability [ipv4-unicast | ipv4-
multicast | route-refresh]
Description
This command enables BGP Multiprotocol (MP) and route-refresh capabilities for a peer-group.
Syntax Description
Default
All capabilities are disabled by default.
Usage Guidelines
NOTE
This command is not generally supported, and is not recommended for general use. However, to inter-operate with
Cisco routers for BGP graceful restart, you must enable IPv4 unicast address capability.
This command enables BGP Multiprotocol and route-refresh capabilities for a peer group. After the
capabilities have been enabled, the BGP peer will announce its capabilities to neighbors in an OPEN
message.
Example
The following command enables the route-refresh feature for the peer group outer:
enable bgp peer-group outer capability route-refresh
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
peer-group-name Specifies a peer group.
ipv4-unicast Specifies BGP MP unicast capabilities.
ipv4-multicast Specifies BGP MP multicast capabilities.
route-refresh Specifies ROUTE-REFRESH message capabilities.