Extreme Networks ExtremeWare XOS - Configure Ports Auto-Polarity

configure ports auto-polarity
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
317
configure ports auto-polarity
configure ports [<port_list> | all] auto-polarity [off | on]
Description
Configures the autopolarity detection feature on the specified Ethernet ports.
Syntax Description
Default
Enabled.
Usage Guidelines
This feature applies to only the 10/100/1000 BASE-T ports on the switch.
Use the
all keyword to enable or disable the autopolarity detection feature on all of the Ethernet ports
on the Summit X450 family of switches and the BlackDiamond 8800 series switch (formerly known as
Aspen).
When autopolarity is disabled on one or more Ethernet ports, you can verify that status by using the
command:
show ports information detail
NOTE
Autopolarity detection is always on for the BlackDiamond 10808 and 12804 switches.
Example
The following command disables the autopolarity detection feature on ports 5 to 7 on the Summit X450
series switch:
configure ports 5-7 auto-polarity off
History
This command was first available in ExtremeWare XOS 11.2.
port_list Specifies one or more ports on the switch.
all Specifies all of the ports on the switch.
off Disables the autopolarity detection feature on the specified ports.
on Enables the autopolarity detection feature on the specified ports.