Extreme Networks ExtremeWare XOS - Show Vman

show vman
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
785
show vman
show vman {<vlan_name> {eaps | ipv4 | ipv6} | etherType | detail {ipv4 |
ipv6}}
Description
Displays vMAN information including configuration and Ethertype.
NOTE
The information displayed on this command depends on the platform and configuration you are using.
Syntax Description
Default
Summary information for all vMANs on the device.
Usage Guidelines
The information displayed with this command depends on the platform and configuration you are
using.
Display on the BlackDiamond 10808 and 12804 switch only. If you configured MAC-in-MAC tunneling
(802.1ah) on the switch, the
show vman displays information on the BVLANs and the SVLANs as well.
(You can display the same information using the
show bvlan or show svlan command.
NOTE
To display the Ether Type for MAC-in-MAC tunneling (802.1ah), you must use the show vman ethertype
command.
Display on the BlackDiamond 12804 R-Series switch only. If you configured vMAN ACLs on the
BlackDiamond 12804 R-Series switch and you designated one port to handle flooding, broadcast, and
multicast traffic egressing the vMAN, use the
show vman <vman_name> detail command to display
the information.
vlan_name Specifies information is displayed for particular vMAN.
eaps Displays the EAPS domains to which the vMAN belongs.
ipv4 Specifies IPv4.
ipv6 Specifies IPv6.
etherType Specifies that Ethertype information is vMAN and, if configured, BVLAN (MAC-
in-MAC) applications.
detail Specifies all information is displayed for each vMAN.