BGP Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1768
enable bgp peer-group
enable bgp peer-group <peer-group-name>
Description
Enables a peer group and all the neighbors of a peer group.
Syntax Description
Default
Disabled.
Usage Guidelines
You can use BGP peer groups to group together up to 200 BGP neighbors. All neighbors within the peer
group inherit the parameters of the BGP peer group. The following mandatory parameters are shared
by all neighbors in a peer group:
● remote AS
● source-interface
● out-nlri-filter
● out-aspath-filter
● out-route-map
● send-community
● next-hop-self
Example
The following command enables the BGP peer group outer and all its neighbors:
enable bgp peer-group outer
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
peer-group-name Specifies a peer group.
To Next Page
Loading...