Extreme Networks ExtremeWare XOS - Show Iparp

show iparp
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1399
show iparp
show iparp {<ip_addr> | <mac> | vlan <vlan_name> | permanent} {vr
<vr_name>}
Description
Displays the IP Address Resolution Protocol (ARP) table. You can filter the display by IP address, MAC
address, VLAN, or permanent entries.
Syntax Description
Default
Show all entries, except for proxy entries.
Usage Guidelines
Displays the IP ARP table, including:
● IP address
● MAC address
● Aging timer value
● VLAN name, VLAN ID and port number
● Flags
If you do not specify a virtual router, the command applies to the current virtual router.
The show output displays the following information:
ip_addr Specifies an IP address.
mac Specifies a MAC address.
vlan_name Specifies a VLAN name.
permanent Specifies permanent entries.
vr_name Specifies a virtual router.
Dynamic entries The number of dynamic (learned ARP) entries in the table.
Static entries The number of configured (static ARP) entries in the table.
Pending entries The number of sent ARP requests that have not yet received a response.
In Request The number of ARP request packets received (by this virtual router).
In Response The number of ARP reply packets received (by this virtual router).
Out Request The number of ARP request packets sent (by this virtual router).
Out Response The number of ARP reply packets sent (by this virtual router).
Failed requests The number of failed ARP requests sent (by this virtual router).
Proxy Answered The number of ARP requests answered by the ARP proxy.