Extreme Networks ExtremeWare XOS - Configure Vlan Name

configure vlan name
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
743
configure vlan name
configure vlan <vlan_name> name <name>
Description
Renames a previously configured VLAN.
Syntax Description
Default
N/A.
Usage Guidelines
You cannot change the name of the default VLAN “Default.”
NOTE
If you use the same name across categories (for example, STPD and EAPS names), Extreme Networks recommends
that you specify the identifying keyword as well as the actual name. If you do not use the keyword, the system may
return an error message.
Example
The following command renames VLAN vlan1 to engineering:
configure vlan vlan1 name engineering
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
vlan_name Specifies the current (old) VLAN name.
name Specifies a new name for the VLAN.