EAPS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1152
show eaps shared-port
show eaps shared-port {<port>} {detail}
Description
Displays shared-port information for one or more EAPS domains.
Syntax Description
Default
N/A.
Usage Guidelines
If you enter the show eaps shared-port command without the detail keyword, the command
displays a summary of status information for all configured EAPS shared ports.
If you specify an EAPS shared-port, the command displays information about that specific port.
Otherwise, the command displays information about all of the shared-ports configured on the switch.
In an EAPS shared port configuration, the segment ports are sorted in ascending order based on their
port number, not the order you add an EAPS domain to EAPS shared ports. This is particularly useful
when planning your EAPS configuration.
NOTE
The order you add EAPS domains to EAPS shared ports is relevant if the EAPS domains have matching ring ports
and participate in spatial reuse. In this case, the newly added EAPS domain is added to the list and sorted on its
ring port AFTER all other EAPS domains with the matching ring port.
The benefit of sorting ports in ascending order is evident if a common link fails. The port with the
lowest port number among the segment ports in the “UP” state becomes the “Active Open” port. When
configuring your EAPS domain, keep the port numbers in mind. For high bandwidth links, utilize
lower port numbers, and for low bandwidth links, utilize higher port numbers. This way, if a common
link fails, the high bandwidth link is still available.
You can use the
detail keyword to display more detailed status information about the segments and
VLANs associated with each shared port.
port Specifies a shared-port.
detail Specifies to display the status of all segments and VLANs.
To Next Page
Loading...