QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
896
configure traffic queue aggregate-meter
configure traffic queue <queue_name> aggregate-meter <metername>
Description
Configures the aggregate rate limit for the HQoS queue by associating the specified queue with the
specified meter.
Syntax Description
Default
N/A.
Usage Guidelines
You use this command with all types of HQoS traffic queues: ingress-only, ingress queues that allow
egress shaping, and egress queues.
This command creates the aggregate rate limit for the specified queue by associating that queue with
the meter containing a peak rate value.
Example
The following command configures the test traffic queue with an aggregate rate limit specified by the
peak rate in the m1_100 meter:
configure traffic queue test aggregate-meter m1_100
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available only on the BlackDiamond 12804 R-Series switch.
queue_name Specifies the traffic queue you are configuring.
metername Specifies the meter you are associating with this queue, which contains the
peak rate for the queue.
To Next Page
Loading...