Extreme Networks ExtremeWare XOS - Configure Log Target Syslog

configure log target syslog
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
591
configure log target syslog
configure log target syslog [all | <ipaddress> | <ipPort>] {vr <vr_name>}
{local0 ... local7} from <source-ip-address>
Description
Configures the syslog server’s IP address for one or all syslog targets.
Syntax Description
Default
If a virtual router is not specified, the following virtual routers are used:
● ExtremeWare XOS 10.1—VR-0
● ExtremeWare XOS 11.0 and later—VR-Mgmt
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
Use this command to identify and configure the syslog server’s IP address. By configuring a source IP
address, the syslog server can identify from which switch it received the log message.
Options for configuring the remote syslog server include:
● all—Specifies all of the remote syslog server hosts.
● ipaddress—The IP address of the remote syslog server host.
● ipPort—The UDP port.
● vr_name—The virtual router that can reach the syslog host.
● local0-local7—The syslog facility level for local use.
● from—The local source IP address.
syslog Specifies a syslog target.
all Specifies all of the remote syslog servers.
ipaddress Specifies the syslog server’s IP address.
ipPort Specifies the UDP port number for the syslog target.
vr_name Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
local0 ... local7 Specifies the local syslog facility.
source-ip-address Specifies the local source IP address to use.