enable ripng
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1521
enable ripng
enable ripng
Description
Enables RIPng for the whole router.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
Although RIPng is useful in small networks, it has a number of limitations that can cause problems in
large networks, including:
● A limit of 15 hops between the source and destination networks
● A large amount of bandwidth taken up by periodic broadcasts of the entire routing table
● Slow convergence
● Routing decisions based on hop count; no concept of link costs or delay
● Flat networks; no concept of areas or boundaries
For larger networks, consider OSPFv3 as an alternative IGP.
Example
The following command enables RIPng for the whole router:
enable ripng
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...