Extreme Networks ExtremeWare XOS - Unconfigure Ospfv3

OSPFv3 Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1660
unconfigure ospfv3
unconfigure ospfv3 {domain <domainName>} {area <area-identifier> | vlan
<vlan-name> | tunnel <tunnel-name>}
Description
Resets one or all OSPFv3 interfaces to the default settings.
Syntax Description
Default
N/A.
Usage Guidelines
ExtremeWare XOS OSPFv3 allows you to change certain configurable OSPFv3 parameters on the fly.
This command selectively resets the configurable parameters to their default values. The following is
the list of parameters whose values will be reset to their defaults:
● Interface
■ Hello Interval
■ Dead Interval
■ Transmit Delay
■ Retransmit Interval
■ Priority
■ Cost
● Area
■ All the parameters of Interfaces associated with this area
■ Inter-Area-Prefix-LSA Filter
■ AS-External-LSA Filter
● OSPF Global
■ All parameters of all areas in this OSPF domain
■ SPF Delay interval
domainName Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
area-identifier Specifies an OSPFv3 area, a four-byte, dotted decimal number.
vlan-name Specifies an IPv6 configured VLAN.
tunnel-name Specifies an IPv6 tunnel.