Extreme Networks ExtremeWare XOS - Configure Eaps Shared-Port Link-ID

EAPS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1136
configure eaps shared-port link-id
configure eaps shared-port <ports> link-id <id>
Description
Configures the link ID of the shared port.
Syntax Description
Default
N/A.
Usage Guidelines
Each common link in the EAPS network must have a unique link ID. The controller and partner shared
ports belonging to the same common link must have matching link IDs. No other instance in the
network should have that link ID.
If you have multiple adjacent common links, Extreme Networks recommends that you configure the
link IDs in ascending order of adjacency. For example, if you have an EAPS configuration with three
adjacent common links, moving from left to right of the topology, configure the link IDs from the lowest
to the highest value.
Example
The following command configures the EAPS shared port 1:1 to have a link ID of 1.
configure eaps shared-port 1:1 link-id 1
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms with a Core or an Advanced Core license.
ports Specifies the port number of the common link port.
id Specifies the link ID of the port. The link ID range is 1 to 65535.