QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
870
configure dot1p type
configure dot1p type <dot1p_priority> {qosprofile} <qosprofile>
Description
Configures the default QoS profile to 802.1p priority mapping.
Syntax Description
Default
The default mapping of each 802.1p priority value to QoS profile is shown in Table 24.
Usage Guidelines
An 802.1p priority value seen on ingress can be mapped to a particular QoS profile and with specific
bandwidth management and priority behavior.
BlackDiamond 10808 and 12804 switch only. If a port is in more than one virtual router, you cannot use
the 802.1p feature. If you attempt to configure 802.1p information on a port that is in more than one
virtual router, the system returns the following message:
Warning: Port belongs to more than one VR. Port properties related to diff serv and
code replacement will not take effect.
BlackDiamond 8800 series switches and Summit X450 family of switches only. You must create the QoS
profile first, using the
create qosprofile [QP2| QP3 | QP4 | QP5 | QP6 | QP7] command, to
map the 802.1p information to QoS profile 2 through 7.
dot1p_priority Specifies the 802.1p priority value. The value is an integer between 0 and 7.
qosprofile Specifies a specific QoS profile.
Table 24: Default 802.1p priority value-to-QoS profile mapping
Priority value
BlackDiamond 10808 and
12804 switch QoS profile
BlackDiamond 8800 series switch and Summit
X450 family of switches default QoS profile
0 QP1 QP1
1 QP2 QP1
2 QP3 QP1
3 QP4 QP1
4 QP5 QP1
5 QP6 QP1
6 QP7 QP1
7 QP8 QP8
To Next Page
Loading...