Extreme Networks ExtremeWare XOS - Configure Syslog Delete

configure syslog delete
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
621
configure syslog delete
configure syslog delete [all | <ipaddress> | <ipPort>] {vr <vr_name>}
{local0 ... local7}
configure syslog delete <host name/ip> {: <udp-port>} [local0 ... local7]
Description
Deletes a remote syslog server address.
Syntax Description
Default
If a virtual router is not specified, VR-Mgmt is used.
If a UDP port number is not specified, 514 is used.
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
This command is used to delete a remote syslog server target.
Example
The following command deletes the remote syslog server with an IP address of 10.0.0.1:
configure syslog delete 10.0.0.1 local1
History
This command was first available in ExtremeWare XOS 10.1.
The
ipPort parameter was first available in ExtremeWare XOS 11.0.
all Specifies all remote syslog servers.
ipaddress Specifies the remote syslog server IP address.
ipPort Specifies the UDP port number for the syslog target.
vr_name Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
local0 ... local7 Specifies the local syslog facility.