Extreme Networks ExtremeWare XOS - Configure Snmpv3 Add Filter-Profile

configure snmpv3 add filter-profile
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
135
configure snmpv3 add filter-profile
configure snmpv3 add filter-profile [[hex <hex_profile_name>] |
<profile_name>] param [[hex <hex_param_name>]] | <param_name>] {volatile}
Description
Associates a filter profile with a parameter name.
Syntax Description
Default
The default storage type is non-volatile.
Usage Guidelines
Use this command to add an entry to the snmpNotifyFilterProfileTable. This table associates a filter
profile with a parameter name. The parameter name is associated with target addresses, and the filter
profile is associated with a series of filters, so, in effect, you are associating a series of filters with a
target address.
Example
The following command associates the filter profile prof1 with the parameter name P1:
configure snmpv3 add filter-profile prof1 param P1
History
This command was first available in ExtremeWare XOS 10.1.
The
hex_profile_name and hex_param_name parameters were added in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
hex_profile_name Specifies the filter profile name. The value is to be supplied as a colon
separated string of hex octets.
profile_name Specifies the filter profile name in ASCII format.
hex_param_name Specifies a parameter name to associate with the filter profile. The value to
follow is to be supplies as a colon separated string of hex octets.
param_name Specifies a parameter name to associate with the filter profile in ASCII format.
volatile Specifies volatile storage.