Extreme Networks ExtremeWare XOS - Configure Elrp-Client Periodic

configure elrp-client periodic
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1955
configure elrp-client periodic
configure elrp-client periodic <vlan_name> ports [<ports> | all] interval
<sec> [log | log-and-trap | trap]
Description
Starts periodic ELRP packet transmission on the specified ports of the VLAN using the specified
interval.
Syntax Description
Default
The interval between consecutive packet transmissions is 1 second.
Usage Guidelines
This command starts periodic ELRP packet transmission on the specified ports of the VLAN using the
specified interval. If any of these transmitted packets is returned, indicating loopback detection, the
ELRP client can perform a configured action such as logging a message in the system log file and/or
sending a trap to the SNMP manager.
Use either the
configure elrp-client one-shot or the run elrp command to configure non-
periodic, one-time transmission of ELRP packets.
The ELRP client must be enabled globally in order for it to work on any VLANs. Use the
enable elrp-client command to globally enable the ELRP client.
The ELRP client can be disabled globally so that none of the ELRP VLAN configurations take effect. Use
the
disable elrp-client command to globally disable the ELRP client.
vlan_name Specifies a VLAN name.
ports Specifies the set of VLAN ports for packet transmission.
all Specifies all ports of this VLAN for packet transmission.
sec Specifies the interval (in seconds) between consecutive packet transmissions.
The range is 1 to 600 seconds. The default is 1 second.
log Specifies that a message should be logged in the system log file when ELRP
packets are received back indicating detection of network loop, or no packets
are received within the specified duration.
log-and-trap Specifies that a message should be logged in the system log file and a trap
message should be sent to the SNMP manager when ELRP packets are
received back indicating detection of network loop, or no packets are received
within the specified duration.
trap Specifies that a trap message should be sent to the SNMP manager when
ELRP packets are received back indicating detection of network loop, or no
packets are received within the specified duration.