Extreme Networks ExtremeWare XOS - Unconfigure Qosprofile

QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
942
unconfigure qosprofile
unconfigure qosprofile {ingress | egress} {ports [<port_list>|all]}
Description
Returns the ingress rate shaping parameters, which is an ingress QoS profile, or the egressing QoS
values to default values.
Syntax Description
ingress Specifies all ingress QoS profiles for specified ports. The default ingress values
are as follows:
• for 1G I/O modules—IQP1 and IQP2
• for 10G I/O modules—IQP1 to IQP8
If you do not specify ingress or egress, the command returns all egress QoS
values to default.
NOTE: This parameter is available only on the BlackDiamond 10808 switch.
egress Specifies an egress QoS profile for specified ports. The default egress values
are as follows:
• QP1—1, Low (the lowest priority)
• QP2—2, LowHi
• QP3—3, Normal
• QP4—4, NormalHi
• QP5—5, Medium
• QP6—6, MediumHi
• QP7—7, High
• QP8—8, HighHi (highest priority)
If you do not specify ingress or egress, the command returns all egress QoS
values to default.
NOTE: This parameter is available only on the BlackDiamond 10808 and
12804 switch.
ports Specifies unconfiguring the QoS profiles on specified ports.
NOTE: This parameter is available only on the BlackDiamond 10808 and
12804 switch, the BlackDiamond 8800 a-series and e-series modules, and the
Summit X450a and X450e series switch.
port_list Specifies a list of slots and ports to which the parameters apply.
NOTE: This parameter is available only on the BlackDiamond 10808 and
12804 switch, the BlackDiamond 8800 a-series and e-series modules, and the
Summit X450a and X450e series switch.
all Specifies that this applies to all ports on the device.
NOTE: This parameter is available only on the BlackDiamond 10808 and
12804 switch, the BlackDiamond 8800 a-series and e-series modules, and the
Summit X450a and X450e series switch.