Extreme Networks ExtremeWare XOS - Configure Lldp Ports Vendor-Specific Dot3 Power-Via-MDI

Commands for Configuring LLDP
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
476
configure lldp ports vendor-specific dot3 power-via-mdi
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-
specific dot3 power-via-mdi
Description
Configures the LLDP port to advertise or not advertise Power over Ethernet (PoE) capabilities to its
neighbors.
Syntax Description
Default
No advertise.
Usage Guidelines
When configured, the system includes this TLV. Extreme Networks recommends enabling this TLV only
on PoE-capable ports.
The following information is transmitted for LLDP ports with this TLV:
● Support PoE or not
● Port class
■ Power sourcing equipment (PSE)
■ Powered device (PD)
● Power pairs used to supply power
■ Signal
■ Spare
● Power status
● Support pairs control or not
● Power class
■ Class0
■ Class1
■ Class2
■ Class2
■ Class3
■ Class4
all Specifies all ports on the switch.
port_list Specifies one or more ports or slots and ports.
advertise Specifies to send the information to neighbors.
no-advertise Specifies not to send the information to neighbors.