Extreme Networks ExtremeWare XOS - Disable Log Target

Commands for Status Monitoring and Statistics
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
632
disable log target
disable log target [console | memory-buffer | nvram | primary-msm | backup-
msm | session | syslog [all | <ipaddress> | <ipPort>] {vr <vr_name>}
[local0 ... local7]]]
Description
Stops sending log messages to the specified target.
Syntax Description
Default
Enabled, for memory buffer, NVRAM, primary MSM, and backup MSM; all other targets are disabled
by default.
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
This command stops sending messages to the specified target. By default, the memory buffer, NVRAM,
primary MSM, and backup MSM targets are enabled. Other targets must be enabled before messages
are sent to those targets.
console Specifies the console display.
memory-buffer Specifies the switch memory buffer.
nvram Specifies the switch NVRAM.
primary-msm Specifies the primary MSM.
NOTE: This parameter is available only on modular switches.
backup-msm Specifies the backup MSM.
NOTE: This parameter is available only on modular switches.
session Specifies the current session (including console display).
syslog Specifies a syslog target.
all Specifies all of the remote syslog servers.
ipaddress Specifies the syslog host name or IP address.
ipPort Specifies the UDP port number for the syslog target.
vr_name Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
local0 ... local7 Specifies the local syslog facility.