Extreme Networks ExtremeWare XOS - Show Version

show version
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
705
show version
show version {detail | process <name> | images {partition <partition>} {msm
<slotid>} }
Description
Displays the hardware serial and version numbers, the software version currently running on the
switch, and (if applicable) the software version running on the modules and power controllers.
Syntax Description
Default
N/A.
Usage Guidelines
The following describes the information displayed when you execute the show version or show
version detail
commands:
● Part Number—A collection of numbers and letters that make up the part number of the switch and
when applicable the hardware components installed in a modular switch.
● Serial Number—A collection of numbers and letters that make up the serial number of the switch
and when applicable the hardware components installed in a modular switch.
NOTE
For information about the physical location of the serial number on your switch, refer to the section that
describes your specific switch model in the Extreme Networks Consolidated XOS Hardware Guide.
● Image—The ExtremeWare XOS software version currently running on the switch. If you have two
software images downloaded on the switch, only the currently running ExtremeWare XOS version
information is displayed. The information displayed includes the major version number, minor
version number, a specific patch release, and the build number. The software build date is also
displayed.
● BootROM—The BootROM version currently running on the switch.
detail Specifies display of slot board name and chassis or platform name.
process Specifies display of all of the processes on the switch.
name Specifies display of a specific process on the switch.
images Specifies the display of installed images.
partition Specifies display of a specific partition (primary or secondary).
slotid Specifies display of an MSM in a specific slot (A or B).
NOTE: This parameter is available only on modular switches.