Extreme Networks ExtremeWare XOS - Configure Snmpv3 Add Filter

configure snmpv3 add filter
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
133
configure snmpv3 add filter
configure snmpv3 add filter [[hex <hex_profile_name>] | <profile_name>]
subtree <object_identifier> {/<subtree_mask>} type [included | excluded]
{volatile}
Description
Adds a filter to a filter profile.
Syntax Description
Default
The default values are:
● mask value—empty string (all 1s)
● type—included
● storage—non-volatile
Usage Guidelines
Use this command to create a filter entry in the snmpNotifyFilterTable. Each filter includes or excludes a
portion of the MIB. Multiple filter entries comprise a filter profile that can eventually be associated with
a target address. Other commands are used to associate a filter profile with a parameter name, and the
parameter name with a target address.
This command can be used multiple times to configure the exact filter profile desired.
Example
The following command adds a filter to the filter profile prof1 that includes the MIB subtree 1.3.6.1.4.1/
f0:
configure snmpv3 add filter prof1 subtree 1.3.6.1.4.1/f0 type included
hex_profile_name Specifies the filter profile that the current filter is added to. The value is to be
supplied as a colon separated string of hex octets.
profile_name Specifies the filter profile that the current filter is added to in ASCII format.
object identifier Specifies a MIB subtree.
subtree_mask Specifies a hex octet string used to mask the subtree. For example, f7a
indicates 1.1.1.1.0.1.1.1.1.0.1.0.
included Specifies that the MIB subtree defined by <object identifier>/<mask> is to be
included.
excluded Specifies that the MIB subtree defined by <object identifier>/<mask> is to be
excluded.
volatile Specifies volatile storage.