Extreme Networks ExtremeWare XOS - Configure Diffserv Replacement

QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
868
configure diffserv replacement
configure diffserv replacement [{qosprofile} <qosprofile> | priority
<value>] code-point <code_point>
Description
Configures the default egress DiffServ replacement mapping.
Syntax Description
Default
N/A.
Usage Guidelines
NOTE
Extreme Networks recommends that you use the qosprofile <qosprofile> value to configure this parameter.
The default QoS profile to 802.1p priority value to code point mapping is shown in Table 23.
qosprofile Specifies a QoS profile.
value Specifies the 802.1p priority value.
code_point Specifies a 6-bit value to be used as the replacement code point in the
DiffServ (IP-TOS byte) of the IP header.
Table 23: Default QoS profile-to-802.1p priority value-to-code point
802.1p priority value
BlackDiamond 10808 and
12804 switch QoS profile
BlackDiamond 8800 series switch and
the Summit X450 family of switches
QoS profile
Code point
0 QP1 QP1 0
1 QP2 QP1 8
2 QP3 QP1 16
3 QP4 QP1 24
4 QP5 QP1 32
5 QP6 QP1 40
6 QP7 QP1 48
7 QP8 QP8 56