Extreme Networks ExtremeWare XOS - Disable Stpd Rapid-Root-Failover

disable stpd rapid-root-failover
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1213
disable stpd rapid-root-failover
disable stpd <stpd_name> rapid-root-failover
Description
Disables rapid root failover for STP recovery times.
Syntax Description
Default
Disabled.
Usage Guidelines
This command is applicable for STPDs operating in 802.1D.
After you have created the STPD with a unique name, the keyword
stpd is optional.
To view the status of rapid root failover on the switch, use the
show stpd command. The show stpd
command displays information about the STPD configuration on the switch including the enable/
disable state for rapid root failover.
Example
The following command disables rapid root fail over on STPD Backbone_st:
disable stpd backbone_st rapid-root-failover
History
This command was available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
stpd_name Specifies an STPD name on the switch.