Extreme Networks ExtremeWare XOS - Configure Sys-Recovery-Level

Commands for Status Monitoring and Statistics
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
608
configure sys-recovery-level
configure sys-recovery-level [all | none]
Description
Configures a recovery option for instances where a software exception occurs in ExtremeWare XOS.
Syntax Description
Default
The default setting is all.
Usage Guidelines
If the software fails, the switch automatically reboots or leaves the system in its current state. You must
specify one of the following parameters for the system to respond to software failures:
● all—The system will send error messages to the syslog and reboot if any software task exception
occurs.
● none—No action is taken when a software task exception occurs. The system does not reboot, which
can cause unexpected switch behavior.
NOTE
Use the none parameter only under the guidance of Extreme Networks Technical Support personnel.
If the system recovery level is all, the system always reboots after a software task exception. This is the
default setting and behavior, and Extreme Networks strongly recommends using the default setting.
Displaying the System Recovery Setting. To display the software recovery setting on the switch, use the
following command:
show switch
This command displays general switch information, including the software recovery level. The
following truncated output from a Summit X450 series switch displays the software recovery setting
(displayed as
Recovery Mode):
SysName: TechPubs Lab
SysLocation:
SysContact: support@extremenetworks.com, +1 888 257 3000
all Configures ExtremeWare XOS to log an error into the syslog and reboot the
system after any software task exception occurs.
none Configures the recovery level to none. No action is taken when a software task
exception occurs; there is no system reboot, which can cause unexpected
switch behavior.
NOTE: Use this parameter only under the guidance of Extreme Networks
Technical Support personnel.