Extreme Networks ExtremeWare XOS - Configure Inline-Power Label Ports

Power Over Ethernet Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
514
configure inline-power label ports
configure inline-power label <string> ports <port_list>
Description
Lets you create your own label for a specified PoE port or group of PoE ports.
Syntax Description
Default
No label.
Usage Guidelines
Use the show inline-power configuration ports command, as shown in the following example, to
display inline power configuration information, including the label (if any) for each port:
show inline-power configuration port 3:1-10
Following is sample output from this command:
Port Config Operator Limit Priority Label
3:1 Enabled 16000 mW Low finance
3:2 Enabled 15000 mW Low finance
3:3 Enabled 15000 mW Low
3:4 Enabled 15000 mW Low
3:5 Enabled 15000 mW Low
3:6 Enabled 15000 mW Low marketing
3:7 Enabled 15000 mW Low marketing
3:8 Enabled 15000 mW Low marketing
3:9 Enabled 15000 mW Low
3:10 Enabled 15000 mW Low
Example
The following command assigns the name “alpha-test_1” to port 1 on slot 4:
config inline-power label alpha-test_1 ports 4:1
History
This command was first available in ExtremeWare XOS 11.1.
string Specifies a name up to 15 characters in length to identify the specified power
port(s).
port_list Specifies one or more ports or slots and ports.