Extreme Networks ExtremeWare XOS - Show Traffic Queue

QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
934
show traffic queue
show traffic queue {detail | <queue_name>}
Description
Use this command to view the current ingress-only and ingress and egress HQoS configuration on your
switch.
Syntax Description
Default
N/A.
Usage Guidelines
Allows you to display the HQoS configuration on your switch, as follows:
● Names of traffic queues
● Direction of traffic queues
● Allow egress shaping
● HQoS mode
● Associated queue meter
Example
The following command displays the rate limiting configuration for your switch:
show traffic queue
The following is an example of the output of this command:
------------------------------------------------
Traffic Queue Direction Shape Egress
-------------------------------------------------
limit Egress N/A
peggy Ingress Yes
sample Ingress No
The following command displays more detail about each HQoS traffic queue:
show traffic queue detail
detail Specifies displaying greater detail about all configured traffic queues.
queue_name Specifies displaying greater detail about the specified traffic queue.