Power Over Ethernet Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
532
enable inline-power slot
enable inline-power slot <slot>
Description
Enables PoE power to the specified slot on modular switches.
Syntax Description
Default
Enable.
Usage Guidelines
Disabling inline power to a slot immediately removes power to any connected PDs. By default, inline
power provided to all slots is enabled.
To deliver inline power to slots, you must reserve power for that slot using the configure inline-power
budget slot command. By default, each PoE module has 50 W of power reserved for inline power.
NOTE
If your chassis has an inline power module and there is not enough power to supply a slot, that slot will not be
powered on; the slot will not function in data-only mode without enough power for inline power.
Disabling inline power using the disable inline-power command does not affect the data traffic
traversing the slot. And, disabling the slot using the
disable slot command does not affect the inline
power supplied to the slot.
Example
The following command makes inline power available to slot 3:
enable inline-power slot 3
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on the G48P and G48Pe modules installed in the BlackDiamond 8800 series
switch.
slot Enables inline power to specified slot.
To Next Page
Loading...