Commands for Configuring LLDP
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
466
configure lldp ports vendor-specific avaya-extreme poe-
conservation-request
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-
specific avaya-extreme poe-conservation-request
Description
Configures the LLDP port to advertise or not advertise a requested conservation level. By default, the
requested conservation value on this proprietary LLDP TLV is 0, which is no power conservation. This
LLDP TLV is sent out only on PoE-capable Ethernet ports.
Syntax Description
Default
No advertise.
Usage Guidelines
The switch sends this proprietary LLDP TLV to request a PD to go into a certain power conservation
level or request the PD to go to the maximum conservation level. This LLDP TLV is transmitted only on
PoE-capable ports.
When configured to advertise, the switch sends this TLV with a requested conservation power level of
0, which requests no power conservation. To temporarily change this conservation level, use the SNMP
lldpXAvExLocPortXPoEPSEPortReqLevel object to set a new value; but the reconfigured value will not
be saved over a reboot. (This SNMP object can be set from 0 to 243 or 255.)
Example
The following command configures all ports to advertise the currently requested conservation level to
neighbors:
configure lldp ports all advertise vendor-specific avaya-extreme poe-conservation-
request
History
This command was first available in ExtremeWare XOS 11.5.
all Specifies all ports on the switch.
port_list Specifies one or more ports or slots and ports.
advertise Specifies to send the information to neighbors.
no-advertise Specifies not to send the information to neighbors.
To Next Page
Loading...