configure bgp peer-group source-interface
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1721
configure bgp peer-group source-interface
configure bgp peer-group <peer-group-name> source-interface [any |
ipaddress <ipAddr>]
Description
Configures the source interface for a peer group and all the neighbors of the peer group.
Syntax Description
Default
N/A.
Usage Guidelines
The source interface IP address must be a valid IP address of a VLAN configured on the switch.
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
Modifying the following parameters automatically disables and enables the neighbors before changes
take effect:
● remote-as
● timer
● source-interface
● soft-in-reset
● password
Example
The following command configures the source interface for the peer group outer and its neighbors on
10.34.25.10:
configure bgp peer-group outer source-interface ipaddress 10.34.25.10
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
peer-group-name Specifies a peer group.
any Specifies any source interface.
ipAddr Specifies an interface.
To Next Page
Loading...